At B & B Supply we offer Safety for your storage rack needs
Back any rack with WireCrafters modular panel system. RackBack® panels bolt directly to your existing pallet rack uprights creating a sturdy barrier between inventory and the ground below. Durable all welded, angle frame panels give constant protection from dangerous spills; protecting personnel while containing inventory. Competitively priced with netting style backing, easy to install, and stock items ready to ship in 48 hours of your order, RackBack® is the system for you.
Features
- Standard sized panels 4’ 0" or 5’ 0" high, match beam length in width.
- Custom size panels available.
- Panels attach directly to rack with mounting brackets.
- Off set brackets allow for load to overhang rack beams.
- Panels can be mounted to support posts-if stand alone system desired.
- Stack panels one on top of the other to top of rack system.
- "Above the Top" mounting allows panels to extend above top rack beam.
- Angle frame design gives installer clear access to hardware, speeding installation.
- Assembly hardware is inaccessible from the exterior of the partition.
- Standard 3/8" assembly hardware is the heaviest in the industry.
- System may be started at the floor or at any level where protection is required.
- Heavier options available.
Popular RACK BACK® Panel Sizes
Panels stocked in 1’ wide increments. Four brackets per panel are required for installation.
Four Foot Panels
| Part No. | Width x Height | Weight |
| 124 | 12'-0" x 4'-0" | 77 |
| 104 | 10'-0" x 4'-0" | 63 |
| 94 | 9'-0" x 4'-0" | 58 |
| 84 | 8'-0" x 4'-0" | 53 |
Five Foot Panels
| Part No. | Width x Height | Weight |
| 125 | 12'-0" x 5'-0" | 90 |
| 105 | 10'-0" x 5'-0" | 74 |
| 95 | 9'-0" x 5'-0" | 68 |
| 85 | 8'-0" x 5'-0" | 63 |
Off-Set Mount Brackets
Panels mount to the pallet rack upright with an offset bracket. Mounting brackets from flush mount to 12" off-set available. Four brackets are required per panel.
Free design and layout assistance available. Call 616-458-1800
Material Specifications
PANELS - Shall be 10gauge steel wire crimped and woven in to 2" x 1" opening rectangular mesh, securely welded into a frame of 1-1/4" x 1-1/4" x 1/8" steel angle factory punched with 7/8" x 7/16" slotted holes to accept 3/8" mounting hardware. Panels four to six feet wide shall have one 1/4" x 3/4" flat stiffener, wider panels receive two 1/4" x 3/4" stiffeners. All panels shall be fastened to posts with 3/8" x 3" plated bolts and nuts.
POSTS - Shall be made of 2" x 2" x 14 gauge steel tubing. Base plates of 2" x 7" x 1/4" steel flat with two 7/16" round holes for anchoring, shall be welded to each tube. Posts are factory drilled with 1/2" holes to accept hardware for mounting panels.
HARDWARE - Shall be 3/8" standard thread grade two plated nuts and bolts. Floor anchors are 3/8" wedge type-provided.
FINISH - Non-plated parts receive one coat of gray acrylic enamel. Touch up paint included with each shipment.